flexible BOX
When laid down, shelves or chairs.
Vertically, the legs of the desk.
Low table when defeated.
Furniture that can be used for many purposes.
I made it myself in 2004.
(Create a total of 8)
Below is a photo I used 17 years ago.
The top plate of the above desk is loaded with pine laminated lumber W1200D600.
The top plate can also be purchased at the following site. (W1400.)
↑ It’s a little difficult to understand, but if you knock it down, it will become a low table.
(Glass is placed on the top plate.)
Flexible BOX is still in active use today.
The photo below is the current one.
(All 8 created in 2004 are still used as of 2021)
The top plate is 4.8M with 3 pieces of Tamo’s 4 width lumber W1600D750t35 lined up.
Four flexible boxes as legs for the desk counter.
Two are used as chairs and the other two are used as printer stands.
Similar products of the top plate can be purchased from the following site.
(↓Japan HP)
I use it as a printer stand,
By chance, the printing paper fits perfectly.
The concept is
① Simple and timeless design, and versatile
(2) Since it is made of solid wood (Western red cedar), it can be used for a long time because it feels aged.
③Since the material uses mass-produced products, it can be produced at low cost.
How to create.
Create with W700D235H476. (Unit is mm)
Dimensions are the most important.
The material used is mass-produced SPF material 2×10.
The regulation width of 235 mm remains the same, and the lengths are 700 mm x 2 and 400 mm x 2.
You can combine to create one flexible BOX.
Materials can also be purchased from:
Rakuten Ichiba Two-by Material W910D235 t38
If you make it with reference to this blog, here are some notes.
① The sitting height is 476 mm, so it is a little higher.
Fine-tune the dimensions to suit your body size and taste.
(2) The joint is only fixed with screws. I used a stainless steel screw of about 10 cm and made a pilot hole for the screw. I think it’s tough if you don’t have an electric screwdriver when installing the pilot holes and screws. I also need a saw to cut the material.
How to create.
Create with W700D235H476. (Unit is mm)
Dimensions are the most important.
We are waiting for comments and photos of those who actually challenged the creation.